Yoke, Wheel and Lightgun Gaming Box v2.0

Upgrade instructions:

We’ve shipped them in the sleeve for the full size SD card because they are so small and easy to lose. You will need to take the micro SD card out of that sleeve.

1. Switch off the power to the gaming box.

2. The current Gaming Box SD card is located between the two USB ports on the side of the box. There is a slight dimple that should make it fairly easy to remove by pushing it in slightly and letting it pop out. If that is difficult, then use a fingernail or something sharp to poke it in slightly and pop it out.

3. Insert the new SD card in the same way the old one came out. They only fit one way.

******************

FIRST BOOT UP ONLY

Find the skinny plastic stick provided and locate the audio port at the back of the Gaming Box.

Inside the audio port, at the very bottom, there is a little button. You will be able to feel it if you stick the plastic stick in and fish around a bit. It’s can be a bit tricky to find, but you will feel it when you press it successfully.

You will need to hold that button down for about 4 seconds while turning on the power. If you hold it too long and get to a text menu, unplug it and try again.

******************

 4. Once you restore power, it should boot back up properly with the new version. NOTE: You will lose any saved game data from the previous version.

5. AUDIO - the audio port in the Gaming Box will no longer work with this build. HDMI sound must be used. Usually connecting external speakers to the audio port in your TV or monitor will work, but if that isn't an option, then an HDMI extractor will need to be used.